Push gently to latch the cover into place. Pull a short length of paper up and over the screen to get it started, and close the compartment. Make sure the paper feeds from underneath the roll instead of from the top. Place the roll inside with the feeding edge facing toward the screen. Load the receipt paper into the VX520 by lifting the cover of the top compartment. If you’re still having trouble, this guide to the Verifone VX520 can give you additional instructions with pictures for each step. Plug these in if you’re using them, and replace the back panel of the unit. The VX520 also has two USB ports so that you can connect external units as desired. For Internet payment processing, plug the Ethernet cable into the port labeled “ETH.” If you’re on a dial-up connection, look for the phone icon and plug in the phone cord. Locate the appropriate icon for your communication connection, and pair up the corresponding cable. Connect the quarter-inch plug to the port, and ensure it locks into place. The port for this is located above the labeled area. The ports used depend on the type of connection over which you’ll be processing payments. You’ll see several different connecting ports with corresponding colored labels. Turn the unit over, and open the bottom compartment. Getting the VX520 ready to accept payments is simple. Verify all the components are present before beginning setup. Problems can arise when your hardware device is too old or not supported any longer.A streamlined countertop design makes the VX520 suitable for use anywhere with access to a power supply and a phone or internet connection.
This will help if you installed an incorrect or mismatched driver. Try to set a system restore point before installing a device driver. It is highly recommended to always use the most recent driver version available.
Connect the terminal/PINpad using USB and power up the terminal. The driver will be installed without any UI. If the port is not mentioned then the installation takes the default port as COM9. : The user can provide the required COM port as a parameter. Ensure that the device is unplugged from the PC. Create a folder usbdriver, if does not exists. Extract the contents of the zip file to c:\usbdriver. Download the zip file that is provided.
0 kommentar(er)
